SKF Central System Liquid Lubrication Distributors
SKF MonoFlex Piston distributors for single line lubrication systems Piston distributors adjust the amount of lubricant and deliver this lubricant to the lubrication area with an intermittent pump. Adjusting the appropriate amount of lubricant for the individual lubrication points is done with adjustment nipples. There is a statement on each nipple showing the amount of lubricant. In addition, the amount of lubricant required for the entire system can be precisely adjusted by changing the lubrication frequency.
Flow rate: 0,14 l/min. Pump pressure: 38 bar. Central lubrication pump KFU2-40+924. Central lubrication pump KFU2-30+924. For utility vehicles. The single line unit KFU2-40 is able to supply virtually any system size in utility vehicles, including superstructures, with a single pump. Please choose your product from the options below. VOGEL Centralized Lubrication Systems 10000US 2 Singleline total loss lubrication system For relatively small, consumptionoriented amounts of oil per lube point and intermittent oil delivery. The oil delivery units are manually, mechanically, hydraulically or pneumatically actuated piston pumps or intermittently oper ated gear pumps. Manual grease pump incl. 400gr grease cartridge Grease class: II Flow rate: ca. 2 cm³/stroke Installation: any Counter pressure: SKF Manual Grease Pump with Block Metering Device vogel-zentralschmierung.de. DEVCO CORPORATION. 131 MORRISTOWN ROAD. BASKING RIDGE, NJ 07920 USA. Toll Free: 1-800-323-3826. Lubrication pumps and pump assemblies Lubrication pumps supply the lubricant from a storage container via a pipeline system to the distributors or directly to the lubricating points. The feed pressure has to be big enough to compensate the pressure loss in the pipelines and on the interconnected components such as filters, valves and distributors. Microsoft office para macbook air.
In order to obtain the required amount of lubricant and meet the requirements of the application, it is possible to use four distributor groups with different lubricant delivery amounts and sizes. Although the working principle of these distributor groups is the same, their designs are different. Different groups of distributors can also be used within an installation.
Attention please! Felt material: NBR.
In general, the operating conditions specified for the respective pump units apply equally to distributors.
Limit values for distributors:
Temperature range: 0 to + 80 ° C (32 to 176 ° F)
Effective lubricant viscosity:
5 to 2 500 mm² / s
Working principle
1. The amount of lubricant required for the lube points is in front of the piston in the distributor. 2. When the central lubrication pump starts to deliver the oil, the piston moves forward and presses the lubricant in front of it to the lubrication point at 12 to 45 bar main line pressure. 3. After the main line has been depressurized (1 bar), the distributor piston returns to its original state and the set amount of lubricant fills the space in front of the piston again.
Piston distributors, group 340
0.01 - 0.16 cm³ (for oil)
Piston distributors, group 350
0.1 - 0.6 cm³ (for oil) Vogel Lubrication Catalog
Piston distributors, group 390
0.2 - 1.5 cm³ (for oil) Comments are closed.
|
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2021
Categories |